Teledyne-lecroy Serial Data Debug Solutions Manuale Utente Pagina 180
- Pagina / 204
- Indice
- SEGNALIBRI
Valutato. / 5. Basato su recensioni clienti
Serial Data Debug Solutions
180
919586 RevA
SATA Trigger Setup Detail
The following topic provides specific control settings for a SATA Trigger setup.
PLEASE NOTE THE FOLLOWING:
Most Trigger Setups have some form of Source and Type control.
Only the Symbol Type uses Setup Mode and Symbol Detail controls.
Remaining dialog controls vary based on the selected Pattern Type and are explained in the following
sections.
1. SETUP
Bus Speed - Select the desired bitrate of the connected SATA source from 1.5 Gbps, 3 Gbps, or Auto.
Host Channel - Select the input channel that contains the Host device (C1, 2, 3, or 4). Typically this refers
to the SATA transmitter. If the transmitter is unavailable, select None.
Device Channel - Select the input channel that connects to the SATA device (C1, 2, 3, or 4). This typically
refers to the SATA receiver. If a receiver is not available, select None.
Note: If using two single-ended probes, select the channel that corresponds to the positive terminal.
Direction - Select whether to trigger on the Host or Device.
2. FORMAT
Depending on the pattern type, use this control to select either hexadecimal or binary formats.
3. PATTERN TYPE
Pattern Type selections include Symbol, Primitive, FIS Pattern, Data Payload, Protocol Error, and Bus Condition.
REMAINING DIALOG CONTROLS BASED ON PATTERN TYPE SELECTION
Symbol Pattern Type Selection Controls
With this pattern type selected, triggering is performed on a specified 8B/10B character. Remaining controls on
the dialog vary based on a Symbol Pattern Type selection in the following manner:
- Serial Data Debug Solutions 1
- TABLE OF CONTENTS 3
- Overview 9
- The D and TD Toolsets 12
- The ProtoSync Toolset 26
- Physical Layer Eye Diagram 32
- Debug Examples 32
- Using the 8b/10b Option 45
- Using the I2Cbus Option 53
- Using the SPIbus Option 58
- Using the CANbus Option 68
- Using the LINbus Option 73
- Using the FlexRaybus Option 77
- Serial Audio Protocol 87
- Using the ARINC 429 Option 97
- Operator's Manual 101
- Using the DigRF 3G Option 118
- Using the DigRF v4 Option 122
- Using the MIPI M-PHY 145
- Using the SAS Option 155
- Using the PCIe Option 163
- Using the SATA Option 175
- Using the USB2 Option 183
- Using the USB3 Option 191
- Reference 196
- Specifications 199
- Contact LeCroy for Support 199
Prodotti e manuali riguardandi Software Teledyne-lecroy Serial Data Debug Solutions
Software Teledyne-lecroy QPHY-UWB Manuale Utente
(30 pagine)
(30 pagine)
Software Teledyne-lecroy SDA II Manuale Utente
(38 pagine)
(38 pagine)
Parat příručky
Seznam Parat produktových deivces obsahuje 3 uživatelské příručky a návody pro 3 modelů v 3 typech zařízení
Commenti su questo manuale