Teledyne-lecroy Serial Data Debug Solutions Manuale Utente Scaricare il pdf (Pagina 176)

Serial Data Debug Solutions

176

919586 RevA

SATA Decode Setup Detail

For general information about using controls shown on the main Serial Decode dialog, refer to Accessing The D

and TD Supported Protocol Toolsets (on page 13).

SATADECODER AND EXPORTER RIGHT-HAND DIALOGS

Access the Serial Decode dialog by touching Analysis → Serial Decode on the menu bar.

Touch the corresponding Setup... button for your decode. The Decode Setup... along with the SATADecoder

right-hand dialog is shown.

SATADecoder Right-Hand Dialog

The SATADecoder right-hand dialog provides detailed controls and setup conditions as follows:

 Select a Speed value from 1.5, 3.0, and 6.0 Gbps choices.

 Configure the Probe Selection control based on whether you're using One Differential Probe or Two

Single Ended Probes.

 Mark the Detect OOB checkbox as desired.

Note: As indicated on the dialog, since OOB detection is time consuming, it's best to only use if truly

necessary.

SATA Protocol Exporter Right-Hand Dialog

The SATA Protocol Exporter right-hand dialog provides detailed controls for synchronizing and sending your

data to the Protocol Analyzer.

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 203 204

Nessun commento

Teledyne-lecroy Serial Data Debug Solutions Manuale Utente Pagina 176