Teledyne-lecroy SAS_SATA Protocol Suite Verification Script Engine Manuale Utente Scaricare il pdf (Pagina 42)

9.16 SendPairSASAddressOnly()

This function specifies that ONLY the selected Pair-SAS-Address event be sent to the script,

and no other events be sent.

Format : SendPairSASAddressOnly( Source SAS Address, Destination SAS Address )

Parameters

Source SAS Address [ format: raw data ] See SendPairSASAddress() above.

Destination SAS Address [ format: raw data ]

Example

…

SendPairSASAddressOnly ('5000E85000000001', '5000C50000103D91');

# Send only events with the above specified SAS Address Pair.

Remark

If you send two or more events using SendPairSASAddressOnly(), then only the later

function call will be sent to the script. Previous calls will be ignored. For example,

SendPairSASAddressOnly('5000E85000000001', '5000C50000103D91');

# Pair – 1

SendPairSASAddressOnly('500062B000001074', '50060560000003C4');

# Pair – 2

Then only Pair-2 events will be sent to the script.

9.17 DontSendPairSASAddress()

This function specifies NOT to send a selected Pair-SAS-Address event to the script.

Format : DontSendPairSASAddress(Source SAS Address, Destination SAS Address)

Parameters

Source SAS Address [ format: raw data ] See SendPairSASAddress() above.

Destination SAS Address [ format: raw data ]

Example

…

SendAllPairSASAddress();

DontSendPairSASAddress('5000C500001047B5', '5000C50000103D91');

# This sends all events to the script except the one with a pair

# SAS address mentioned inside DontSendPairSASAddress()

9.18 SendAllPairSASAddress()

This function specifies to send events with all possible combinations of the above specified set

of SAS Addresses.

Format : SendAllPairSASAddress()

Example

…

SendAllPairSASAddress();

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 96 97

Nessun commento

Teledyne-lecroy SAS_SATA Protocol Suite Verification Script Engine Manuale Utente Pagina 42