Teledyne-lecroy USB2-HSIC Decoder Manuale Utente Scaricare il pdf (Pagina 10)

USB2/USB2-HSIC Decode and Trigger

Enabling/Disabling the Decoder

Once preset, the four decoders can be enabled simultaneously or separately, although this number may be

limited depending on the type of source channels selected. Preset decoders can be easily disabled without

disrupting the configuration.

To enable:

Press the Front Panel Serial Decode button (if available on your oscilloscope), or choose Analysis > Serial

Decode, to open the Serial Decode dialog, then check Decode On next to the respective decoder.

If View Decode is checked (default) for that decoder on the Decode Setup dialog, a result table and decoded

waveform appear. The number of rows of data displayed on each table will depend on the Table#Rows

setting. The default is one, which can be increased, but doing so will decrease the amount of the screen

available to display traces.

To disable:

Deselect the Decode On box individually, or touch Turn All Off.

922295 RevA

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Nessun commento

Teledyne-lecroy USB2-HSIC Decoder Manuale Utente Pagina 10