Teledyne-lecroy CANbus TD and CANbus TDM - Operators Manual Manuale Utente Scaricare il pdf (Pagina 24)

CANbus Trigger, Decode, and Measure

CANbus-TD-TDM-OM-E RevB

CAN-to-Analog Parameter Setup

To access the setup dialog, touch Setup for that particular parameter on the CAN

Measure/Graph Setup dialog. The Px Parameter dialog will be displayed. On the right side of this

dialog box, there is an additional setup dialog:

The CAN Message tab defines the CAN Message Setup. The Analog Signal tab defines the Analog

Signal Setup.

Note: The CAN Message tab always defines the CAN Message Setup and the Analog Signal tab

always defines the Analog Signal setup even if you are measuring time from an Analog Signal

to a CAN Message. The CAN Message setup is nearly identical to the setup of the CAN message

in the CAN Trigger dialog, so details will not be repeated here.

The Analog Signal setup dialog is shown below:

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 68 69

Nessun commento

Teledyne-lecroy CANbus TD and CANbus TDM - Operators Manual Manuale Utente Pagina 24